Adomast Plastrip S Maximum Concentration Release Oil – 25 Litre

Adomast Plastrip S Maximum Concentration, Low-medium Viscosity, Mould Release Oil.

Plastrip S is a chemical release agent specifically formulated to give easy release of plastic and thermoplastic mould liners, providing a high quality surface finish, but is suitable for all types of formwork. It is easily applied and may be applied to formwork immediately prior to casting without reducing the finished quality. Plastrip S will also offer corrosion protection to any metal surface.

This variant is supplied as a 25 litre unit.

Advantages:

• Suitable for use on plastic mould liners with excellent results.
• Is a suspension and sediment free, highly mobile liquid, which can be used in very fine sprays without clogging the jets
• No unpleasant odour even when using a fine fog spray
• Very economic coverage rates can be obtained without difficulty.
• Retains its mobility at low temperatures.
• It may be applied immediately prior to casting, or treated forms may be left until apparently dry
• Plastrip S may be used for metal or timber mould boxes holding the mould liner, allowing easy cleaning of all equipment.
• Can be used with either grey or white cement or concretes incorporating pigments.
• Provides quick positive release of form-liners, reducing labour costs and damage to formwork and liners.
• Drastically reduces the incidence of blowholes, surface blemishes and staining

Coverage:

A recommended thin coating gives a coverage between 30 to 40m2 per litre depending upon surface porosity. Care should be taken to ensure that Plastrip S is applied as recommended as this will achieve optimum performance and maximum economy.

Application:

Plastrip S is ready to use and should not be diluted. It should be applied as thinly and evenly as possible for optimum performance. It can be applied to all types of formwork and mould liners by spray, fine haired brush, swab or roller. Any excess should be mopped up. For the best and most economical performance application by fine fog spray is recommended. It will not clog fine jets even at freezing temperatures.