Adomast Adopatch Fairing Coat Repair Mortar – 25kg

Adomast Adopatch Fairing Coat 25kg repair mortar for repairing thin sections and blowholes.

Adopatch Fairing Coat is a single component polymer modified levelling material specially formulated to re-profile concrete in thin applications without cracking.

This variant is supplied as a 25kg sack.

Uses:

Adomast Adopatch Fairing Coat 25kg is designed for application to concrete surfaces which are to receive a compatible protective coating. Improves the aesthetic appearance of concrete surfaces, fills honeycombing and blow holes and levels up concrete surfaces.

Advantages:

• Single component- easy to use.
• High polymer content- reduces the risk of cracking.
• High bond strength.
• Cost-effective – easily over coated preventing excessive consumption of coatings.
• Fair-faced finish.

Coverage:

Coverage approx.15m2 at 1mm deep.

Application:

Mixing: Adopatch Fairing Coat should be mixed using water which complies with BS EN 1008 (as for concrete).

Adopatch Fairing Coat should be mixed in a suitable container using either an electric (1Kw) or pneumatic power tool. Larger amounts MUST be mixed in a FORCED ACTION paddle mixer.

25kg of /Fairing Coat should be added carefully to 7 litres of water, progressively mixing until a good render consistency is achieved.

Once mixed the material must not be re-worked.

Placing: All areas to be treated should be clean and sound and free from dust, laitance or any other deleterious material which would interfere with the bonding of the product to the concrete.

Wet grit blasting is the ideal preparation however high pressure water jetting or other suitable mechanical means can be used.

The prepared substrate should be thoroughly soaked with clean water and uniformly saturated with no free standing water.

Priming is not normally required with this product unless the substrate is highly porous and there is excessive suction. If priming is deemed necessary then follow the procedure on the Adomast Concrete Primer A technical data sheet.

Adopatch Fairing Coat should be applied in layers not exceeding 6mm in thickness using a suitable steel or wooden float taking care to avoid air entrapment.