Adomast Adopatch Kerb Repair Mortar – 25kg

Adomast Adopatch Kerb Repair 25kg – Rapid-Setting, Quick Return to Service Kerb Repair Mortar.

Adomast Adopatch Kerb Repair 25kg is a single-component rapid-setting cementitious repair mortar facilitating quick return to service. The mortar has a working time of 10-15minutes and a setting time of 20-30 minutes at 20 degrees C. It has been developed for the rapid repair of kerb stone, cracks and holes in flooring, walls, stairs and steps. It can be ready for overcoating within 90 minutes. It is suitable for vertical applications – no cracks or sagging. It is shrinkage compensated and crack-free.

The application thickness is 2-20mm unfilled and 20-50mm when blended with an equal weight of a graded aggregate.

This variant is supplied as a 25kg unit.

Advantages:

• Working Time 10-15minutes.
• Setting time 30 minutes
• Rapid setting mortar that facilitates quick return to service
• Easy to use – mix only with clean water
• Slump free – Easy to smooth & Float
• Ideal for the rapid repairs to damaged kerb stones, cracks & holes in flooring, stairs & steps
• Ready for overcoating within 90 mins @ 2mm
• Suitable for vertical applications.
• High Build 20-50mm.

Application:

Instructions for Use: Ensure surface is sound, clean, and free from laitance, loose materials, oil, grease or other surface contaminants. If necessary hack surface back to reach a sound plane. To ensure proper mixing, a mechanically powered mixer or drill fitted with suitable paddle should be used. Add 1.8 litres of water to a clean container. The powder is then added slowly while mixing continuously with low speed mixer/drill(400-600rpm). Mixing should continue for 3 minutes until a uniform, smooth, slump free consistency is achieved. Only mix enough mortar that can be applied before the product begins to set (approx. 10-15 mins).

Adopatch Kerb repair Mortar can be applied up to a thickness of 20mm. Over 20mm but not exceeding 50mm, should be bulked out with an equal weight of graded aggregate. compounds are best applied in situations up to a maximum of 20mm (range 5-20mm) thickness per layer. The working time will be extend-ed at low temperatures and reduced at higher temperatures. Immediately after completion of mixing apply by clean steel trowel pressing firmly onto surface smoothing and finishing with trowel or float kept moist and clean.

Clean tools and equipment with water before material has hardened. Due to moisture retention of the polymer no special curing procedure is generally necessary excepting in high ambient temperatures or windy conditions when it is advisable to take precautions to prevent rapid drying of the compound