Tremco ES200 Fast-Curing Universal DPM – 6kg Kit

Tremco ES200 Fast-Curing Universal DPM is a a solvent free, two part, epoxy based damp proof membrane which achieves emicode EC1 status. Developed specifically for suppressing residual moisture in concrete and sand/cement subfloors and provides a guaranteed surface damp proof membrane with a single coat liquid application.

This product is supplied as a 6kg kit.

Product benefits:
– Accommodates up to 97% RH
– Suitable with underfloor heating
– Very cost effective single coat application reducing time on site
– Cures in half the time of conventional epoxy based surface damp proof membranes
– Suitable for heated concrete and sand cement screeds (provided the surface temperature does not exceed 27°C in accordance with BS 8203 and BS 5325

Application:
Tremco ES200 is so easy to apply that it could be over extended; therefore, measure out areas of 15 m² (up to 92% RH) or 12.5 m² (up to 97%) to ensure correct coverage for a 1 x 6 kg unit and to give the correct coating thickness of approximately 250 – 350 microns (dependent on system selected).

A practical coverage of approximately 12.5 m²-15 m² per 6 kg unit is expected, dependent on application and porosity of the concrete subfloor. Pour all of the ES200 onto the prepared concrete immediately after mixing then apply with a 2 mm x 5 mm notched 
trowel. While the ES200 is still wet, flatten out the serration ridges with a long handled, short pile roller, initially prewetted in the ES200. Replace or re-notch worn trowels to ensure that the correct thickness of ES200 is maintained.

Protective Equipment:
USE IN WELL VENTILATED CONDITIONS and ensure all recommended protective equipment is worn during handling & use of this product. For full recommendation, refer to safety data sheet.

Colour
When mixed: Gun metal grey
Part A: Dark grey
Part B: Brown

Packaging
Units of 6 kg in metal containers.

Standards
All aspects of the installation must be in accordance with the requirements of BS 8204, BS 8203 (Installation of Resilient Floor coverings) or BS 5325 (Installation of Textile Floor coverings) and
supplementary specifications.

Accreditations
EC1

Moisture Testing
(in accordance with British Standards 8203) 

• Hygrometer readings must be taken and recorded so that the correct system can be selected.
• Concrete curing compounds and over-trowelled concrete will extend
  the time taken for the hygrometer to reach equilibrium.
• Subfloor measurement readings of up to 97% RH (measurable) can be accommodated with the system (99.9% theoretically).